.
Modification of a Swapp Barier mechanical module with 2 cylinders without orange support plate
The original part is required
Modification of a Swapp Barier mechanical module without the 2 cylinders and the orange support plate
The original part is required
Refurbishment of AGR cylinder compression machine including :
- Recovery of the machine from site
- Survey of existing system
- Cleaning
- Replacement of control valve
- Replacement of water supply tube
- Small supplies (magnets, fixings, etc.)
- 110Vac test of motor and compression shafts
- Leak check of the filling and return water
- Delivery to Vergèze site
Test bench for 5x standard valves and 2x EMHART proportional valves with current control allowing the control and visualisation in real time of the pressure variation according to the current applied.
It includes :
- Chassis with test table maximum width 140cm maximum depth 80cm maximum on castors and bases
- Generator, transformer
- Electric box with emergency stop
- 80mm diameter cylinder with 200mm stroke
- Pressure sensor with display
- Pressure and cut-off valve
- Oscilloscope
- Proportional signal sending sockets
- 1/2 day on-site training
Test bench for 5x standard valves (I34, MK55, Mac 45, 11SAD, BV26)
It includes :
- Chassis with test table maximum width 120cm maximum depth 80cm maximum on castors and base plates
- Generator, transformer
- Electric box with emergency stop
- 80mm diameter cylinder with 200mm stroke
- Pressure sensor with display
- Pressure and cut-off valve
- Oscilloscope
Test bench for 5x standard valves and 2x EMHART proportional valves with current control allowing the control and visualisation in real time of the pressure variation according to the current applied.
It includes :
- Chassis with test table maximum width 140cm maximum depth 80cm maximum on castors and bases
- Generator, transformer
- Electric box with emergency stop
- 80mm diameter cylinder with 200mm stroke
- Pressure sensor with display
- Pressure and cut-off valve
- Oscilloscope
- Proportional signal sending sockets
- 1/2 day on-site training
Mechanical Charpy Impact test machine for glass container testing
Impact speed : 35Inch Per Second
5 in 5 IPS increments up to 120 with a minimum of 10
Adjustable bottle height for impact testing at friction zones with 3mm screw thread for quick manual set up
Minimum impact height of 10mm possible
Container rotation by the operator